Category – Avionics – Accessories
Fuel Flow Transducer | 7-90 GPH, Hall Effect, Right Angle Pick-up
Fuel Flow Transducer | 7-90 GPH, Hall Effect, Straight Pick-up
TRANSDUCER 200GPH/W/RA PICK UP
The transducer is a device that converts the mechanical motion of a spinning turbine into an electronic signal that is read by the fuel computer. The magnetic pick-up assembly detects the spinning turbine and counts the revolutions. This produces a series of pulses that is transmitted to the fuel computer. The computer uses the pulse frequency to calculate the fuel flow over time. The Shadin Avionics Company Incorporated-designed fuel flow transducer can be used in conjunction with all of our fuel totalizer units and fuel/airdata computers.
Call for Pricing
Contact Cost Aero at 855-500-3044 for pricing
TRANSDUCER 200GPH W/COIL TOP/ST PICK UP
The transducer is a device that converts the mechanical motion of a spinning turbine into an electronic signal that is read by the fuel computer. The magnetic pick-up assembly detects the spinning turbine and counts the revolutions. This produces a series of pulses that is transmitted to the fuel computer. The computer uses the pulse frequency to calculate the fuel flow over time. The Shadin Avionics Company Incorporated-designed fuel flow transducer can be used in conjunction with all of our fuel totalizer units and fuel/airdata computers.
Call for Pricing
Contact Cost Aero at 855-500-3044 for pricing
TRANSDUCER/70GPH W/RA PICK-UP
10-70 GPH Fuel Flow Transducer with Right Angle Pick-up. These transducers are made of stainless steel and meet all FAA requirements for installation in the engine compartment without additional heat or flame shielding. These transducers have excellent linearity and immunity from viscosity variation due to fuel temperature variation and low locked rotor pressure drop.
Call for Pricing
Contact Cost Aero at 855-500-3044 for pricing
DIGIFLO-L/SINGLE/LITERS/IF
Fuel Flow Transducer | 7-160 GPH, Hall Effect, Right-Angle Pick-up
This fuel flow transducer mounts to the engine fuel line and produces electrical signals that represent the fuel flow. The transducer body has hydraulic fittings that connect directly to the engines fuel line, and a small turbine wheel mounted inside with two precision ball bearings driven by the flowing fuel which incorporate a small magnet that is picked-up by a hall-effect sensor. Transducers based on hall effect technology can operate over a broader range of flow rates and in high temperature environments. This transducer also includes an integrated RTD temperature sensor.
1-2 week lead time most likely
Contact Cost Aero at 855-500-3044 for pricing
CC250 dual secondary 400Hz Transformer
FAA-PMA Magneto Noise Filter
This magneto noise filter will suppress EMI-RFI (popping) noise with our FAA-PMA approved ignition noise filter. It easily connects to the primary P-Lead and grounds at the magneto metal twist cap and magneto body. The Magneto Filter is a feed through design with self healing film capacitor technology that greatly increases the ability to filter and extends the reliability of the filter.
Plastic Converter Connector Kit with Solder Cup | 5 Pin, 10 A
This Plastic Converter Connector Kit with Solder Cup is a plastic connector hood with a back-shell, 4-40 hardware and 25 Pin d-sub and 5 high current (10 Amp) pins. Designed for the LS03-05003 converter line the kit is a ruggedized connector back-shell that will protect the dc converter, db connector and pins from airborne harsh environments.
