OAT Probe
The Outside Air Temperature (OAT) probe has an outside aluminum shield which is used to both hold the probe in place and shield it from radiated heat. When installing the OAT probe, shield the sensor from direct sunlight and engine heat. The OAT probe is installed in the airframe manufactures recommended location, if this information is not available, we recommend installing the probe in clean airflow such as in a cabin air scoop or below the underside of the wing away from engine heat or exhaust heat.
- 1 Thermocouple Type K OAT Probe
- 1-10 Ft. Option Wire
CRB Probe
TIT Probe
TIT 7/16-20 Screw in Type Probe
CDT Probe
OAT Probe
RAMI AV-64 Marker Beacon
The AV-64 is a boat type marker beacon antenna designed for very low drag. It is constructed of an acrylonitrite-styrene-acrylic (ASA) shell with the internal parts encapsulated in rigid urethane foam for mechanical and electrical stability. The white color allows for maximum performance without losses due to color pigments or unseen dirt.
The antenna is supplied with cellular neoprene mounting pad and hardware.
The antenna is designed to operate at speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 0.22 lbs @ 250 mph. This antenna is a direct replacement for the CI 102.
RAMI AV-200 Airborne ELT
The AV-200 ELT antenna is intended for use with a 406 MHz ELT (Emergency Locator Transmitter) for General Aviation. It is a passive two frequency wire whip, designed for low speed aircraft (up to 250 knots). It has met DO-160G, Section 8, Category U requirements for robust vibration and is qualified for installation on helicopters with unknown related rotor frequencies.
