6752-100 Series Circuit Breaker | 90 Amp Rating, Push Button
Avionics Pin Test Kit
Teflon Coax Cable | BNC to BNC, 10ft
3TC2 Series Circuit Breaker | 35 Amp Rating
RAMI AV-535 Bent Whip Antenna | FM Extended Band
Artex ME406 Series Lithium Battery Pack
A200-TSA Outside Air Temperature Sensor
The A200-TSA is a monolithic temperature sensor with on-chip signal conditioning and an operating temperature of -50°C to 150°C. It has an accuracy of +/- 0.5°C over the full operating range.
The output voltage is proportional to the temperature x the supply voltage (ratiometric). The output swings from 0.25 V at −50°C to +4.75 V at +150°C using a single +5.0 V supply.
The temperature transfer function is:
VOUT = (V+/5 V) × [1.375 V +(22.5 mV/°C) × TA]
Power requirements are 5V / 1mA.
The sensor has a 5/16-24 threaded body and is supplied with two nylon mounting washers and a Nyloc fastening nut.
Supplied with a 48" color coded cable.
When installed in accordance with the approved instructions and as part of a qualified instrument system, this temperature sensor is STC'd as a primary replacement.
TC90 Controller with installation kit (dual upgrade)
Light Wedge Power Inverter | 24VDC–28VDC, 120V/400Hz Output
The 10-800 series power inverter is designed for powering up UMA EL instrument lighting bezels. This unit converts DC current to AC current uses two wires setup to deliver 120-volt/400Hz power. Up to 30 UMA light bezels maybe connected or three large EL lights in parallel to one another (Beechcraft Bonanza).
This 10-800 inverter operates on 24 VDC — 28 VDC.
Variable Intensity Lighting Controller
Variable Intensity Lighting Controller - REV 1 Instrument ONLY
NOTE: This item is only required for use on products purchased BEFORE 03-JAN-2013
ONLY USE THIS ITEM TO REPLACE AN EXISTING REV A UNIT IF IT HAS FAILED.
Products manufactured after this date have this unit INCLUDED and are connected to the panel lighting system or a separate potentiometer.
The A200-DDC Intensity Controller will support up to ten Rev 1 instruments in a single installation. It provides infinitely variable, uniform intensity control for all instruments.
These units are TSO qualified with all 200 Series instruments and is STC'd as a primary replacement instrument component under all flight conditions (day/night VFR and IFR).
