Shop

The Outside Air Temperature (OAT) probe has an outside aluminum shield which is used to both hold the probe in place and shield it from radiated heat. When installing the OAT probe, shield the sensor from direct sunlight and engine heat. The OAT probe is installed in the airframe manufactures recommended location, if this information is not available, we recommend installing the probe in clean airflow such as in a cabin air scoop or below the underside of the wing away from engine heat or exhaust heat.

• 1 Thermocouple Type K OAT Probe
• 1-10 Ft. Option Wire

The Carburetor Temperature Probe (CRB) probe, is installed in the Carburetor throat. A pre-drilled 1/8 NPT port is available from

The Turbine Inlet temperature (TIT) probe, is installed in the exhaust stack accumulator to a maximum depth of 1/2 inches and approximately 2-4 inches from the turbine inlet, on the wastegate side of the turbine. The TIT probe is shipped with a #48 stainless steel clamp.