OAT Probe
The Outside Air Temperature (OAT) probe has an outside aluminum shield which is used to both hold the probe in place and shield it from radiated heat. When installing the OAT probe, shield the sensor from direct sunlight and engine heat. The OAT probe is installed in the airframe manufactures recommended location, if this information is not available, we recommend installing the probe in clean airflow such as in a cabin air scoop or below the underside of the wing away from engine heat or exhaust heat.
- 1 Thermocouple Type K OAT Probe
- 1-10 Ft. Option Wire
Manifold Pressure Sensor
Fuel Flow Transducer 231
The Fuel Flow Transducer measures flows of hydrocarbon fuels such as gasoline, kerosene, and #2 diesel fuel and other light transmitting, non-corrosive liquids of similar viscosity. Typical fuel flow applications include aircraft fuel monitoring systems; gasoline, diesel, and gas turbine engine test stands; and industrial furnaces.
The transducers give repeatable signals on gasoline across a 100 to 1 flow range down to 0.3 GPH. The higher viscosity of diesel fuel reduces signal repeatability at flow rates below 2 GPH. Pressure drops are very low compared to other turbine flow transducers. The transducer bearing system is rated for continuous operation at the upper end of the flow range.
The transducers produce a current pulse signal from an opto-electronic pickup with a preamplifier.
Fuel Flow Transducer 201B
The Fuel Flow Transducer measures flows of hydrocarbon fuels such as gasoline, kerosene, and #2 diesel fuel and other light transmitting, non-corrosive liquids of similar viscosity. Typical fuel flow applications include aircraft fuel monitoring systems; gasoline, diesel, and gas turbine engine test stands; and industrial furnaces.
The transducers give repeatable signals on gasoline across a 100 to 1 flow range down to 0.3 GPH. The higher viscosity of diesel fuel reduces signal repeatability at flow rates below 2 GPH. Pressure drops are very low compared to other turbine flow transducers. The transducer bearing system is rated for continuous operation at the upper end of the flow range.
The transducers produce a current pulse signal from an opto-electronic pickup with a preamplifier.
CRB Probe
CHT Gasket Probe
The Cylinder Head Temperature (CHT) – Gasket Type (Washer) – You may install the probe on the upper or lower spark plug (the one that provides the best correlation with the other temperature probe). Due to the sparkplug location, the gasket probe may read 25’F higher (generally the sparkplug is the hottest part of the cylinder, which will cause this discrepancy).
- 1 Thermocouple Type K CHT Gasket Probe
TIT Probe
TIT 7/16-20 Screw in Type Probe
IAT Probe
