Standard Multi-Circuit Toggle Switch | 6 pole, On-None-On + False

A Flight Bag or Travel Bag that can handle all your gear. Adaptable by adding or removing center sections as needed. Eight different bags can be built with the included modules. Eight bags for the price of one.

The D3•Hover combines a CS3 as a wonderfully slim module for drones, along with the Pack Cap Rear to allow the bag to be configured as a backpack for those times when you need to fly and be on the move at the same time, and of course, the Pocket Cap Front for all the small stuff.

NOTE: This price DOES NOT INCLUDE ANY FOAM. This bag is configured with no foam, so you'll have to add either the Drone Foam for the DJI Spark, or the Drone Foam for the DJI Mavic Air, since these are the two foam sets designed to fit inside the CS3.

The FLEX POCKET CAP REAR is exactly the same as the POCKET CAP FRONT, except it's the "opposite": This module goes onto the Rear surface of any other FLEX module (not the Front).

Now you can have lots of small pockets on the REAR of your bag, to go along with all the small pockets you already have on the Front.

The FLAT CAP REAR zips onto the Rear surface of all FLEX Center Sections and also directly onto a Front End Cap (PCF, FCF).

This module offers two thin pockets on the outer surface and also a thin half-height flap pocket on the inner surface. The convertible panel on the back gives you the ability to slide your BrightLine Bag onto the telescoping handles of a rolling suitcase or folding cart.