1 Round Hole Punch

The Greenlee Round Hole Punches make instrument hole cutting for 1″”, 2-1/4″” and 3-1/8″” holes quick and easy. Here’s how it works:

• (1) Layout hole location, draw centerlines so that they extend beyond the hole size to be punched.
• (2) Drill proper size pilot hole in the center.
• (3) Put drive screw through die and pilot hole.
• (4) Thread on punch until both die and punch are ight against metal.
• (5) Line up center lines of the hole with marks on outside of the die.
• (6) Turn drive screw with open end or box wrench (clockwise) until hole is punched.
• (7) Remove punch from drive screw and the metal halves will fall out.

NOTE: You can use the Hydraulic Ram Kit (P/N:7646) with the round hole punches instead of turning the drive screw with a wrench.