Category – Avionics – ELT
C406-1 HM
The Artex C406-1 HM transmits on all 3 emergency frequencies (121.5/243.0 and 406 MHz). The ELT automatically activates during a crash and transmits the standard swept tone on 121.5 and 243.0 MHz. It also transmits a 406 MHz encoded digital message to the Cospas/Sarsat satellite system, which allows for rapid identification and reduces Search and Rescue response time.
2-Wire ELT/RSWT Interface
The 2-Wire Remote Interface is a follow-up to the ME406 ACE ELT. The ME406 ACE emergency locator transmitter is a replacement for current ACK or Ameri-King 121.5 MHz ELTs, and comes complete with a remote switch and adapters to utilize existing wiring. The 2-Wire ELT/RSWT Interface uses just two of the existing wires from the wiring harness to connect the new cockpit remote switch to any of the 406 MHz series of ELTs.
ELT to Nav Interface
When you’re facing an emergency situation, have peace of mind knowing that with the ELT to Nav Interface, search and rescue teams will have the knowledge of your position, within 100 meters. The ELT to Nav Interface is designed to be connected between the aircraft’s Flight Management Computer (FMC) or GPS receiver, and any of the 406 MHz series of ELTs. This allows your position to be transmitted along with your distress signal.
DGL-1
With the Artex DGL-1 programming dongle, fleet operators will be able to efficiently transfer ELTs from aircraft to aircraft. The DGL-1 is a perfect match for the operator who wants auto-programming capability, but does not desire the position data function of the Artex ELT/NAV Interface. The DGL-1 comes attached to a top cover, which, along with the dongle, remain with the aircraft. When an ELT is installed, the DGL-1 re-programs the ELT with the aircraft’s 24-bit address. Bottom line: this device greatly simplifies maintenance and reduces downtime.
Programmed PA for C406-N
ELT 1000 Base Pack | 406MHz, Rod Antenna, Remote Switch, Lithium Battery, Install Kit
Field Programming Tablet | ELT 345/1000/3000/3000HM/4000/4000HM, ME406, C406 series, B406-4, and G406-4
C406-2 ELT System | Dual Output, Rod Antenna, Remote Switch
RAMI AV-701 General Aviation ELT Antenna
This general aviation antenna is intended for use with an ELT (Emergency Locator Transmitter). It is a passive single port three frequency aircraft blade antenna, designed for high speed aircraft. The circuit Board Housing is made from Polycarbonate. This antenna operates at VHF and UHF frequencies.
ResQLink View | 406MHz, Digital Display PLB
ResQLink 400 | 406MHz GPS
4-LED Aircraft Map Light | Green, 12V, 6″ Gooseneck Shaft
RAMI AV-200(-B) Airborne ELT
RAMI AV-300 ELT Communication
The AV-300 ELT antenna is intended for use with a 406 MHz ELT (Emergency Locator Transmitter) for General Aviation. It is a passive three frequency fiberglass rod whip antenna, designed for low speed aircraft (up to 350 knots). It has met DO-160G, Section 8, Category U requirements for robust vibration and is qualified for installation on helicopters with unknown rotor frequencies.
