CI 271 UHF ANTENNA/BNC Female Connector, 400-430 MHz, 50 Ohms, 50 Watts, Airspeed 250 Knots

$311.05
The CI 271 is a UHF radiotelephone stub antenna designed to withstand the environment associated with the underside of an aircraft. The antenna radiator is mechanically captivated and seated against leakage. All exposed metal surfaces are nickel-plated for corrosion resistance and long service.

Intelligent Flap Controller

$309.65
Intelligent Flap Controller (IFC) is an electronic controller designed specifically to operate DC motor actuators, particularly the Van’s Aircraft series of Flap Actuators used in RV type experimental aircraft. IFC provides flap positioning presets that are accessed by a quick tap of the flap switch. IFC is very simple to wire and requires NO flap position sensor.  It is fully compatible with Safety-Trim servo controllers. Model:  
  • Intelligent Flap Controller (IFC-10)

CI-502 Antenna Coupler | Dual VOR, BNC

$308.20
The CI 502 Dual VOR coupler allows the simultaneous use of two VOR receivers from one VOR antenna. The compact design provides for easy installation.

DIE SET/BNC, TNC. For use with RG-58, RG-59, RG-62

$307.80
BNC, TNC. For use with RG-58, RG-59, RG-62 and use with crimp tool 58433-2

PRO-CRIMPER III Crimp Tool/with die assembly 58495-2 for Multimate type III(+) and type VI contacts

$306.71
Includes crimping tool frame 58495-1 with die assembly 58495-2 for crimping Multimate Type III(+) and Type VI Contacts.

SAI 340 Quattro Replacement Battery

$306.38
This replacement battery directly replaces the backup battery in the SAI 340 Quattro four-in-one standby instrument by Sandia Aerospace.

RATCHET HAND CRIMP TOOL for Molex KK .156 crimp terminals , wire size 18-30 gauge.

$306.15
The GMT203 hand tool is used for crimping Molex 0.156-inch KK Trifurcon Series connectors for wire size 18 to 30 gauge.

RAMI AV-12 VOR/LOC/GS Receive Only Antenna

$305.75
The AV-12 is a VOR/LOC/GS receive only antenna which uses a highly efficient technique of molding the elements directly into a high-impact thermo-setting bakelite center insulator. The stainless steel elements are ground to close tolerances to provide a low profile. The antenna is designed to operate at both UHF and VHF frequencies, speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 0.92 lb @ 250 mph.

RAMI AV-100 ELT Antenna

$305.00
This airborne antenna is intended for use with an ELT (Emergency Locator Transmitter) for general aviation. It has a passive two frequency wire whip, designed for low speed aircraft (up to 250 knots). This antenna operates at VHF and UHF frequencies.  It has met DO-160G, Section 8, Category U requirements for robust vibration and is qualified for installation on helicopters with unknown related rotor frequencies.