Vans RV-8 Flex Bolted Quick Release
Finally, a solution for mounting your iPad in the Vans RV-8 cockpit!
These concentric rings suit the Vans RV-8, mounted through the 2" lightening hole in the 4130 steel windshield bow gusset to attach a MyGoFlight quick release base on the port or starboard (or both) sides of the cockpit. Together they form a strong, vibration free and convenient installation. A handy alternative to an iPad knee-mount that typically interferes with the controls. Each kit comes complete with four M4 x 16mm stainless screws.
Select options
This product has multiple variants. The options may be chosen on the product page
Flex Clamp Collar [Robinson Console Bar]
Flex Clamp Collar [Robinson Console Bar] works with the console bar on the pilot side of Robinson R22, R44, and R66 helicopters. The mount secures onto the console bar using the collar and two screws (included). The infinitely articulating and adjustable arm attaches to our Universal Cradle or the iPad Sport Case. Once attached, your device can be viewed in either portrait or landscape mode simply by rotating the device, without having to make any additional adjustments.
Device Holders Sold Separately
Select options
This product has multiple variants. The options may be chosen on the product page
Flex Clamp Square Bar [Airbus]
Flex Clamp Square Bar [Airbus] works with the square bar that goes from the panel across to the window of Airbus/Eurocopter helicopters. The mount is sandwiched onto the square bar and is then secured using the two plates and four screws. The infinitely articulating and adjustable arm attaches to our Universal Cradle or the iPad Sport Case. Once attached, your device can be viewed in either portrait or landscape mode simply by rotating the device, without having to make any additional adjustments.
Device Holders Sold Separately
Flex Clamp Rod [Rosen Sun Visor Rail]
Flex Spar/Strut [Robinson]
This clamping mount works on many spars, struts, and tubes common in Mooney, Husky and other aircraft. Also works well as a Robinson Helicopter Mount, securing to the center spar on the windshield of Robinson R22, R44, and R66 helicopters. The infinitely articulating and adjustable arm attaches to our Universal Cradle or the iPad Sport Case. Once attached, your device can be viewed in either portrait or landscape mode simply by rotating the device, without having to make any additional adjustments.
Device Holders Sold Separately
Flex Suction PRO
Flex Suction PRO - an infinitely articulating and adjustable arm with the ability to hold any iPad or device. The Mount utilizes one vacuum suction cup with a built-in finger pump that informs you if the mount is losing suction. Give it a couple pumps and it is quickly back to full strength.
Please Note: Due to the vacuum pressure we recommend removing this mount when finished with flight. The vacuum pressure can warp acrylic windows or other smooth surfaces if left too long.
Device Holders Sold Separately
Cessna 172D/P172D GFC 500 Autopilot Hardware Kit
Polish ALL Polisher Kit
D3 • Hover
The D3•Hover combines a CS3 as a wonderfully slim module for drones, along with the Pack Cap Rear to allow the bag to be configured as a backpack for those times when you need to fly and be on the move at the same time, and of course, the Pocket Cap Front for all the small stuff.
NOTE: This price DOES NOT INCLUDE ANY FOAM. This bag is configured with no foam, so you'll have to add either the Drone Foam for the DJI Spark, or the Drone Foam for the DJI Mavic Air, since these are the two foam sets designed to fit inside the CS3.
