6TC2 Series Circuit Breaker | 15 Amp Rating
CI 105 DME TRANSPONDER ANTENNA/BNC Female Connector, L-Band, 960-1220 MHz and 1030-1090 MHz, 50 Ohms, Airspeed 400 Knots, cork gasket included, 2 Hole Mount & a White Finish
The CI 105 is a broadband and rugged antenna designed for DME or transponder use. The antenna assembly is encased in a glass reinforced polyester molded shell and has a standard two stud mounting configuration. It includes a BNC connector and covers 960 MHz to 1220 MHz frequencies and is rated to 400 Knots TAS at 25,000 feet.
RAMI AV-532 VOR/LOC/GS Receive Only Antenna
The AV-532 is a VOR/LOC/GS receive only antenna. It consists of taper ground high-strength 17-7PH stainless steel elements to reliably withstand vibration and wind loads. The insulators are weather-sealed compression-molded bakelite with the mounting holes provided. The unit may be mounted with the V pointed either forward or aft. The antenna is designed to operate at speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 3.42 lb @ 250 mph.
TRIG TA10 VHF Com Antenna
Noise Eliminator Filter | 10 Amp, Wide Attenuation
This DC eliminator filter is FAA-PMA approved solution for reducing interference from alternators, strobe and rotating beacons, AC HVAC, DC motors, electronic fuel pumps and any other electrical components prone to produce noise. This device also protects on-board aircraft electronics from power surges and spikes.
M800R Remote Digital Clock Chronometer | 5V, Orange Lighting | Remote Unit
7274-67 Series Circuit Breaker | 20 Amp Rating
Klixon® 7274-67 series circuit breakers are small, lightweight, and low amperage devices specifically designed to protect aircraft and aerospace cables, and components. The 7274 features a trip–free, indicating reset button and is available in standard ratings from 1/2 to 20 amps.
Includes hardware.
CI 507 VOR GS DIPLEXER
PROBE-2FT-RB
A200-TSO Oil Temperature Sensor
The A200-TSO is a monolithic temperature sensor with on-chip signal conditioning and an operating temperature of -50°C to 150°C. It has an accuracy of +/- 0.5°C over the full operating range.
The output voltage is proportional to the temperature x the supply voltage (ratiometric). The output swings from 0.25 V at −50°C to +4.75 V at +150°C using a single +5.0 V supply.
The temperature transfer function is:
VOUT = (V+/5 V) × [1.375 V +(22.5 mV/°C) × TA]
Power requirements (when used with any 200 Series instrument) are 5V / 1mA.
The sensor has a 5/8-18 threaded body and includes a copper crush washer.
Supplied with a 48" color coded cable.
When installed in accordance with the approved instructions and as part of a qualified instrument system, this temperature sensor is STC'd as a primary replacement.
