RAMI AV-586 Antenna Accessories | Coupler
The AV-586 antenna coupler is a signal splitter providing two outputs from a single antenna. The necessity of bringing this product forward comes from advancing technology in avionics. Newer designed navigational radios have only one antenna input to receive all three (VOR/LOC/GS) signals whereas older legacy radios had a separate antenna input for the VOR/LOC signal and another antenna input for the GS signal.
In an aircraft instrument panel with two newer navigational radios the AV-586 is the article that will provide the necessary signals to both radios utilizing a single antenna.
RAMI AV-5 Base Station | VHF
The AV-5 is an economical Ground Plane base station antenna for general aviation. It is ideally suited for use with Unicom transceivers and is field tunable to optimize VSWR at desired frequency. Durably constructed of high quality materials for a long operational life, the antenna is designed to withstand wind speeds up to 100 mph.
Cable ACD-57 to Becker Radios (3ft)
Interface cable to connect a Becker AR/RT-6201 VHF Radio to an ACD-57. Includes interface converter circuitry
Features- D-SUB 15HD Connector and backshell for ACD-57, preconfigured.
- D-SUB 25 connector on the Becker side.
- Includes interface converter circuitry.
RAMI AV-530 Airborne Communications | VHF
The AV-530 is designed for broadband communications. The antenna has a die-cast aluminum base and a tapered stainless steel whip for less drag at higher airspeeds. It is supplied with a weather-sealing gasket and mounting hardware. The antenna is designed to operate at speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 1.65 lb @ 250 mph. This antenna is a direct replacement for the CI 292-1.
3-Pin 28V Aircraft External Power Cable (802-683)
8ft. AN2551 3-Pin aircraft external power cable (included with 2835A, 2835AB2, 2870A and 2870A-B2 Ground Power Units).
Designed to connect an Enhanced Flight ground power unit to standard AN2552 external power receptacle found on most General Aviation aircraft. Rugged polycarbonate shell, assembled with stainless steel hardware. Torch-soldered heavy-duty copper contacts with silver plating. Up to 0 AWG wire. 50% more power handling. Up to 1600A peak.
T-Bar Tool
MARC-70 Install Kit | D Sub Connector
A200-HAS Hall Effect Current Shunt
The A200-HAS is an economical and precise solution for DC current measurement in electrical systems up to +/- 100A in capacity.
The output of the device has a positive slope (Vcc / 2) when an increasing current flows through the primary copper conduction path. The internal resistance of this conductive path is 130 µΩ typical, providing low power loss.
The thickness of the copper conductor allows survival of the device at up to 5× overcurrent conditions. The terminals of the conductive path are electrically isolated from the sensor leads and provide a minimum isolation of 3,000V.
Current sense response time is 3uS.
Power requirements are 3V @ 10mA. Signal output is linear and varies from 0.0V (-100A) to 3.0V (+100). Zero current is represented by 1.5V.
The sensor has two 1/4" terminal posts for connection to the power bus.
Supplied with a 48" color coded cable.
When installed in accordance with the approved instructions and as part of a qualified instrument system, this current sense shunt is STC'd as a primary replacement.
M451 Digital Voltmeter
M451 FEATURES MINIMUM PANEL SPACE LIGHT WEIGHT AUTOMATIC DIMMING SUNLIGHT READABLE DISPLAY VOLTAGE(REMOTE OPTION AVAILABLE) FAA-PMA APPROVED SPECIFICATIONS Range: 8
Select options
This product has multiple variants. The options may be chosen on the product page
