Voltmeter | Remote Sensing |1.25 Round mount
RAMI AV-210 Airborne CAP | VHF
RAMI AV-10 Communications | VHF
The AV-10 is a communications antenna designed for high-performance aircraft applications. It exhibits excellent electrical characteristics and incorporates an efficient aerodynamic 4-bolt mounting base. The antenna essentially matches the styling of the communication antennas currently used on most singles and light twins. The antenna is designed to operate at speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 2.70 lb @ 250 mph. This antenna is a direct replacement for the CI 121.
AOG FEE Aerospace Logic
SmartStart
SmartStart (SS-12v) is an electronic control module that controls the operation of the engine starter system.  SmartStart improves the safety and security of push-button or key-switch starting systems by providing an interlocked and time limited operation of the engine starter. The SmartStart system helps avoid unintentional activation of the engine starting system.
A SmartStart Kit is available, which includes one SmartStart control module, 8 ft. wiring harness, and airspeed switch.
Models:
- SmartStart (SS-12V)
- SmartStart Kit (includes Airspeed switch and wiring harness) (SS-12V-KIT)
Select options
This product has multiple variants. The options may be chosen on the product page
A200-HAS Hall Effect Current Shunt
The A200-HAS is an economical and precise solution for DC current measurement in electrical systems up to +/- 100A in capacity.
The output of the device has a positive slope (Vcc / 2) when an increasing current flows through the primary copper conduction path. The internal resistance of this conductive path is 130 µΩ typical, providing low power loss.
The thickness of the copper conductor allows survival of the device at up to 5× overcurrent conditions. The terminals of the conductive path are electrically isolated from the sensor leads and provide a minimum isolation of 3,000V.
Current sense response time is 3uS.
Power requirements are 3V @ 10mA. Signal output is linear and varies from 0.0V (-100A) to 3.0V (+100). Zero current is represented by 1.5V.
The sensor has two 1/4" terminal posts for connection to the power bus.
Supplied with a 48" color coded cable.
When installed in accordance with the approved instructions and as part of a qualified instrument system, this current sense shunt is STC'd as a primary replacement.
MARC-70 Install Kit | D Sub Connector
T-Bar Tool
3-Pin 28V Aircraft External Power Cable (802-683)
8ft. AN2551 3-Pin aircraft external power cable (included with 2835A, 2835AB2, 2870A and 2870A-B2 Ground Power Units).
Designed to connect an Enhanced Flight ground power unit to standard AN2552 external power receptacle found on most General Aviation aircraft. Rugged polycarbonate shell, assembled with stainless steel hardware. Torch-soldered heavy-duty copper contacts with silver plating. Up to 0 AWG wire. 50% more power handling. Up to 1600A peak.
RAMI AV-530 Airborne Communications | VHF
The AV-530 is designed for broadband communications. The antenna has a die-cast aluminum base and a tapered stainless steel whip for less drag at higher airspeeds. It is supplied with a weather-sealing gasket and mounting hardware. The antenna is designed to operate at speeds up to 350 mph and altitudes up to 50,000 ft. It has a drag force of 1.65 lb @ 250 mph. This antenna is a direct replacement for the CI 292-1.
Cable ACD-57 to Becker Radios (3ft)
Interface cable to connect a Becker AR/RT-6201 VHF Radio to an ACD-57. Includes interface converter circuitry
Features- D-SUB 15HD Connector and backshell for ACD-57, preconfigured.
- D-SUB 25 connector on the Becker side.
- Includes interface converter circuitry.
